Hi,
We just bougght SplineLand ver. 1.0.7 and have an error. When removing a spline from the Insert section and then hit Generate Surface max will crash every time. The error occurs in various scenes and in both Max design 2014 and Max 2011 64 bit.
We made a small scene to clarify - all units are in cm and total area is approx. 2000x2000 cm.
/3dpixel
SplineLand ver. 1.0.7 error
SplineLand ver. 1.0.7 error
- Attachments
-
- 001.jpg (249.2 KiB) Viewed 55106 times
-
- 002.jpg (413.27 KiB) Viewed 55106 times
Re: SplineLand ver. 1.0.7 error
Are you able to post the simple scene example?
Re: SplineLand ver. 1.0.7 error
Bump for this topic...I have recently been experiencing continuous crashes that seem to be specific to the apparent instability of the "Insert" function.
I have always made sure the platforms and insert shapes do not share borders, etc. This is Max2014 and Vray 2.4. Again, it seems to only happen when trying to use and or make changes to insert objects.
So, is SplineLand still being developed?? It is excellent sometimes, but very often seems quick unstable. Sometimes it will generate the mesh fine, but then, seconds after it says complete, it will crash for no obvious cause. (The kind of crash when Max just hangs forever and must be force-quit.)
I have always made sure the platforms and insert shapes do not share borders, etc. This is Max2014 and Vray 2.4. Again, it seems to only happen when trying to use and or make changes to insert objects.
So, is SplineLand still being developed?? It is excellent sometimes, but very often seems quick unstable. Sometimes it will generate the mesh fine, but then, seconds after it says complete, it will crash for no obvious cause. (The kind of crash when Max just hangs forever and must be force-quit.)
Re: SplineLand ver. 1.0.7 error
update should be ready soon