Limiting the area of the geometry?
Posted: Sun Mar 17, 2013 4:12 am
Hi
Just bought it and was wondering - Is there a way to force SL to create the topography within the boundaries of my plan -
If I have topo-lines within a rectangle - SL creates a big mesh which does not respect the rectangle - This is annoying since I have to cut out any residual mesh areas.
Regards
NIR
Just bought it and was wondering - Is there a way to force SL to create the topography within the boundaries of my plan -
If I have topo-lines within a rectangle - SL creates a big mesh which does not respect the rectangle - This is annoying since I have to cut out any residual mesh areas.
Regards
NIR